California Extreme

Arcade Related Discussion => Arcade Repair and Help => Topic started by: mrpinballs on April 12, 2010, 05:01:53 pm

Title: mr & mrs pacman >bally pinball machine
Post by: mrpinballs on April 12, 2010, 05:01:53 pm

hi
i'm having a problem with my mr & mrs pacman pinball ..other than the flipper coils no other coils are working..i'm getting 44.5 at the power module and all fuses tested good...and i all so replaced the solenoid driver board with one from a working machine...and replaced mpu board.with a Ultimate  MPU-CPU board..i don't know what else i can do..every thing was working fine. any one have this problem be for? thanks

Title: Re: mr & mrs pacman >bally pinball machine
Post by: Mark Birsching on April 14, 2010, 02:43:57 pm

Did you check the under-the-playfield fuse?  It is usually located between the flippers (though it could be anywhere).  This is usually the cause when the flippers work and none of the others do.  (It is the only fuse not in the backbox, so it's easy to skip).

Good luck!

Mark

Title: Re: mr & mrs pacman >bally pinball machine
Post by: mrpinballs on April 21, 2010, 01:16:42 pm

i'll check that out....thanks mark :)

Title: Re: mr & mrs pacman >bally pinball machine
Post by: wiskyblandi1 on December 21, 2017, 01:27:13 am

I have the same problem. And take your advice.